Chapter 3 Installing the Router
Connecting to an AC Power Source
Step 3 Tighten the captive screws on the PEM faceplate (Figure 3-14).
Figure | AC PEM |
|
1 | 2 | 3 |
INPUT | OUTPUT OUT | PUT | ||
OK | ||||
OK |
| |||
|
| FAIL | ||
65
INPUT
50/80HZ
66289
4
1 | AC PEM handle | 4 | Power cord receptacle |
|
|
|
|
2 | On/Off switch | 5 | LEDs |
|
|
|
|
3 | Bail latch | 6 | Captive screws |
|
|
|
|
•All electrical connections between the power supply and the backplane are made automatically when the power supply is fully inserted in the power supply bay.
Step 4 Locate the AC power cord and remove it from its shipping packaging. Verify that the AC power cord shipped with the power supply is the correct type for your site.
Note If you have an incorrect type of power cord, contact your service representative for a replacement.
Step 5 Plug the AC power cord into the AC PEM.
|
| Cisco XR 12404 Router Installation Guide |
|
|
|
|
| ||
|
|
| ||
|
|
|
