Cisco Systems XR 12404 manual Removing an RP or Line Card from the Card Cage

Chapter 5 Maintaining the Router

Removing and Replacing an RP or Line Card

Step 1 Identify the RP or line card to be replaced and write down the following information:

•The RP cable connections on the RP.

•The number and type of RP or line card, so that you will know the location of the card when you re-install it or the replacement, in the card cage.

•The network interface cable connection ports, on the RP or line card.

Step 2 On RPs and line cards with multiple ports, start with the left port on the card and disconnect the interface cable connectors from each of the ports.

Step 3 After all of the interface cables are disconnected, loosen the two captive screws on the cable-management bracket and pull the bracket away from the card.

Step 4 Loosen the two ejector lever captive screws at each end of the card faceplate.

Step 5 Simultaneously pivot the ejector levers away from each other to unseat the card from the backplane connector (Figure 5-18).

Figure 5-18 Removing an RP or Line Card from the Card Cage

CLEAN	CLASS 1 LASER PRODUCT
	LASERPRODUKT DER KLASSE
	PRODUIT LASER DE CLASSE 11
	PRODUCTO LASER

DE CLASSE 1

0 1 2 3

C

RI

TI MA M

CAL JORINO

R

GIGABIT ROUTE PROCESSOR

40C48/POS-SR-SC

MBUS

FAIL

ENABLE

CONSOLIDATED SWITCH FABRIC

66243

	Cisco XR 12404 Router Installation Guide
5-30	OL-13830-02