Cisco Systems XR 12406 manual Safety Recommendations, Repacking the Router

Appendix B Repacking the Router

Tools and Equipment

Tools and Equipment

You will need the following tools and equipment to repack the router for shipping:

•Router packaging kit

•ESD-preventive wrist strap

•Number 1 and Number 2 Phillips screwdrivers

•9/16-inch wrench

•10-mm wrench (either open-end or socket)

•Plastic carton straps and strap installation tools

Safety Recommendations

Before you begin the router repacking procedures, review the following safety information:

•The safety recommendations listed in the “Safety and Compliance” section on page 2-2 of this guide.

•The safety warnings listed in the Cisco publication Regulatory Compliance and Safety Information for the Cisco XR 12000 Series Router (Document Number 78-4347-xx) that accompanied your router.

Repacking the Router

Repacking the Cisco XR 12406 router into the shipping container is presented in the following procedure. This procedure assumes you have repacked the accessory kit and have the anchor clips and angle brackets, bolts, screws, and carton that were removed when the chassis was unpacked.

There are three phases in the repacking process:

1.Securing the router to the pallet base (Figure B-2).

2.Reassembling the protective packaging around the router on the pallet base (see Figure B-1).

3.Strapping the entire package to the pallet base (Figure B-3).

	Cisco XR 12406 Router Installation Guide
B-4	OL-13831-01