Cisco Systems XR 12406 manual Router Power Combination, Ac Pdu

Chapter 3 Installing the Cisco XR 12406 Router

Connecting to an AC Power Source

Table 3-6	Required Power Combinations
Router Power		Combination
AC power		1	AC-input power supply
		1 power supply blank
		2	AC-input power supplies
DC power		1	DC-input PEM
		1	PEM blank
		2	DC-input PEMs

Refer to Figure 3-14 and use the following procedure to connect AC power to the

AC PDU.

Note When operating your router on a single power module, the second power module bay must have a blank filler (MAS-GSR-PWRBLANK=) installed to ensure EMI compliance.

Step 1 Attach an ESD-preventive strap to your wrist and connect the leash to the chassis or to another grounded, bare metal surface.

Step 2 Locate the two AC power cords and remove them from their shipping packaging. Verify that the AC power cords shipped with the power supplies are the correct type for your site.

Note If you have received the wrong type of AC power cord, contact your service representative for a replacement.

	Cisco XR 12406 Router Installation Guide
OL-13831-01		3-25