Cisco Systems XR 12406 manual Repeat steps 1 through 3 for any remaining line cards

Chapter 5 Maintaining the Router

Removing and Replacing an RP or a Line Card

Use the following procedure to attach the cable-management bracket and cables to a line card.

Step 1 Orient the top of the cable-management bracket with the top of the line card faceplate (the end opposite the two four-character alphanumeric displays.)

Step 2 Align the two captive screws on the bracket with the threaded insert holes near the ejector levers on each end of the line card faceplate and finger-tighten the screws.

Step 3 Use a flat-blade screwdriver to secure the two captive screws.

Caution Do not overtighten the captive screws; overtightening the screws can

strip the threads on the screw or the insert in the faceplate.

Figure 5-29 Line Card Cable-Management Bracket

CARRIERRX
ACTIVE	CELL	CARRIERRX
	0
		ACTIVE	CELL	CARRIERRX
			0
				ACTIVE	CELL	CARRIERRX
					0
						ACTIVE	CELL

OC-
12/ST	M-4 P

For fiber-optic or

copper cable

line cards

66587

Step 4 Repeat steps 1 through 3 for any remaining line cards.

	Cisco XR 12406 Router Installation Guide
OL-13831-01		5-47