Execute the following script, replacing the parameters with values appropriate for your system. The gw and mask parameters are optional.

[root@(none)]# config_eth0 ip 192.168.51.242 mask 255.255.255.0 gw 192.168.51.1

b.Using the “vi editor”, edit the file(s) causing the problem and then reboot the unit.

[root@(none) root]# saveconf

[root@(none) root]# reboot

c.Check your DNS configuration in the file /etc/resolv.conf, and download the zImage using the ftp command. See "To Save the zImage into the KVM/net’s Flash Memory."

How to Restore the KVM/net’s Configuration to Factory Default

This procedure assumes that the saveconf command has been previously run to save the configuration.

While logged in as root through the console, via Telnet, or via any SSH session, enter the following command.

[root@KVM/net root]# echo 0>/proc/flash/script [root@KVM/net root]# reboot

444

AlterPath KVM/net Installation, Administration, and User’s Guide

Page 460
Image 460
Cyclades User's Guide manual Root@none root# saveconf Root@none root# reboot