Datalogic Scanning 8500 Power-upBeep Control, •No beep, •One beep, •Three beeps, To set the Power-upBeep:, Scan the SWITCH bar code, 1.Scan the SWITCH bar code

Power-up Beep Control

Specifies the type of audible indication that is made when entering scanner -active mode on power-up. Choices are:

•No beep•One beep•Three beepsTo set the Power-up Beep:

1.Scan the SWITCH bar code.

2.Scan your selection from the three bar codes below. You’ll need to cover any unused bar codes on this and the facing page to ensure that the scanner reads only the bar code you intend to scan.

3.Complete the programming sequence by scanning the SWITCH bar code.

POWER-UP BEEP = OFF

Product Reference Guide 6-21