Datalogic Scanning 8500 Mode, PRESS, sounds, COMMENT, scanner, FUNCTION, DURATION, 4 Seconds, 8 Seconds, Momentary (when, Momentary (when, when the beeper, Increments tone

Table A-2. Volume/Tone Push Button Functions

PRESS	FUNCTION	COMMENT
DURATION
		Alternatively, the scanner can be awakened by:
Momentary (when	Wakes scanner from Sleep	- Moving an object through the scan zone.
scanner is asleep)	Mode	- A weight change on the scale.
		- Scanning with an attached auxiliary scanner.
		Press the push button momentarily to increase speaker
Momentary (when		volume. When the loudest volume is reached, a
	Increments volume	repeated press of the push button cycles volume back
scanner is awake)
		to the lowest setting, then volume increases on subse-
		quent press(es). Five volume levels are available.
Hold, then release		Press the push button for approximately 2 seconds,
		then release. Each time this is done, the beeper will
when the beeper	Increments tone
		sound at one of three tones. Stop when the desired
sounds
		tone (high, medium or low) is sounded.
		This mode allows system support personnel to trouble-
		shoot problems with the scanner. Upon entering Scan-
		ner Diagnostic Mode, view the 7-segment display to
	Scanner Diagnostics Modea	view Interface Type, Bootloader Version Number, Appli-
4 Seconds		cation Version Number and Configuration File Number.
		This mode is used to determine if a scanner can read
		bar codes. Press the button for eight seconds or cycle
		power to exit Scanner Diagnostics Mode and reset the
		scanner.
8 Seconds	Resets Scannerb	Only system support personnel should perform a reset.

a. By standard default, this function is normally disabled to prevent accidental activation by users.

b.Users should not perform scanner resets except under the direction of trained systems support person- nel.

A-4 Magellan® 8500 Scanner