RS-232 Host Echo Quiet Interval

This setting specifies the time interval of RS-232 channel inactivity which must transpire before the scanner will break the host echo loop to transmit the bar code data that has just been scanned to the host.

•0 - 100 = Time in 10-millisecond increments. To set the Host Echo Quiet Interval:

1.Scan the SWITCH bar code.

2.Scan the bar code below, SET RS-232 HOST ECHO QUIET INTERVAL. You’ll need to cover any unused bar codes on this and the facing page to ensure that the scanner reads only the bar code you intend to scan.

3.Scan the appropriate digits from the keypad in Appendix C that represent the desired timeout. The selectable range is 0-100, which is the timeout in 10-millisecond increments. Pad all single and double digit numbers with leading zeroes to yield a three- digit entry (000-100).

Examples:

001 = 10ms

005 = 50ms

040 = 400ms

100 = 1,000ms (1 second)

4.The scanner will automatically exit Programming Mode when the appropriate amount of digits have been scanned.

SET RS-232 HOST ECHO QUIET INTERVAL

Product Reference Guide

6-83