EAN-8 128 Supplemental Label ID

This feature specifies an EAN-8 128 Supplemental label ID to be added to bar code data.

The programming feature, RS-232 Label ID Control, designates

whether the Label ID is transmitted as a prefix or suffix or if Label ID is dis-

abled.

NOTE

To set this feature:

1.Scan the SWITCH bar code.

2.Scan the bar code, SET EAN-8 128 SUPPLEMENTAL LABEL ID below. You’ll need to cover any unused bar codes on this and the facing page to ensure the scanner reads only the bar code you intend to scan.

3.Scan the appropriate digits from the keypad in Appendix C that represent the desired Label ID characters; entered as two hex pairs. A table containing the ASCII Character Set and their corre- sponding Hex Values is available in the inside back cover of this manual. ASCII parameters must be input by scanning a pair of hexadecimal digits for each character. Thus, to set a two-character value of AB, bar codes containing the digits ‘4’, ‘1’, ‘4’, and ‘2’ must be scanned. The selectable range for this option is any hex value from 00 to FF.

4.Complete the programming sequence by scanning the SWITCH bar code.

SET EAN-8 128 SUPPLEMENTAL LABEL ID

Product Reference Guide

6-147