4.Verify that the scanner or scanning-scale passes an operational test by observing the following:

Scanner. Pass UPC/EAN bar code labels in front of the scanner’s win- dows. Since the interface cable is not yet connected to the POS terminal, the scanner may be limited to reading only one or two labels (see the note that follows). The scanner indicates when each label has been successfully read by flashing the green scanner light and emitting a good read tone (beep).

 

When not connected to the host, the scanner may be limited to reading only

 

one or two labels. (This limitation is dependent upon the interface type.) To

 

scan multiple labels without connecting to the host, place the unit in Scanner

NOTE

Diagnostic Mode by pressing the Volume/Tone Push Button for four seconds.

 

Scale. If the Yellow LED is not lit, press the Scale Zero Push Button momentarily. If the scale is operating correctly, the yellow LED will illuminate and remain on steady, and the display will show a reading of 0.00 lb (0.000 kg for metric). If the display is blank or

a is displayed, it may be necessary to calibrate the scale before continuing. Refer to Section 5, Calibration, for calibration procedures.

Remote Scale Display. Check to verify that 0.00 lb (0.000 kg for met- ric) is displayed, then place an item on the weighing platter. Verify that the display shows a weight and that the yellow LED goes out. Remove the item and observe that Remote Scale Display shows 0.00 lb (0.000 kg for metric) and that the yellow LED is On.

5.Unplug the AC power cord from the outlet and disconnect the power cord and Remote Scale Display cable from the scanner’s connector panel.

After you have verified that the scanner and scale (if present) are completely functional, continue with the following procedures to complete the installation.

Product Reference Guide

2-19