4.Fully seat the new vertical scan window into the window channel within its bottom retention tabs. Tilt the window in to engage the two tabs at the top of the retainer and carefully snap the window to secure it in place.

5.Clean both sides of the new vertical scan window using a paper towel or lint free cleaning tissues dampened with a mild, water- based glass cleaner. DO NOT use abrasive cleaners or pads.

6.Re-install the platter. Vertical scan window replacement is now complete.Horizontal Scan Window Replacement (WRG)

Wear Resistant Glass (WRG) horizontal scan windows are replaceable and can be removed and replaced following the instructions below.

Sapphire glass does not require replacement, so it is permanently fastened in place. Do not attempt to remove Sapphire glass from the platter.

NOTE

1.Remove the All Weighs™ Platter from the scanner as shown in Figure 3-3.

2.Turn the platter upside down on a clean, dry surface and remove the four screws shown in Figure 3-5.Retain all screws for later re- installation.

3.Once the vertical bezel is freed from the platter, the WRG win- dow can be slid from its channel as shown. Carefully dispose of any damaged glass.

4.Slide a new WRG window fully into the channel.5.Re-install the vertical bezel using the original four screws.

6.Clean both sides of the new WRG window using a paper towel or lint free cleaning tissues dampened with a mild, water-based glass cleaner. DO NOT use abrasive cleaners or pads.

7.Re-install the platter. WRG window replacement is now com- plete.

Product Reference Guide

3-13