A2. Panel operation

By the operator panel you can set following conditions. Other conditions such as print offset, print characters can be set by the host machine.

A2.1 How to set the endorser ON (or OFF)

When you use the endorser, you must set the endorser ON as follows.

<< SETUP MODE >>

Screen 1

<<SETUP MODE >> ENDORSER INITIAL

Screen 2

ENDORSER VALUE

*

ON

0 0 0 0 1

 

 

 

Screen 3

1While pressing the [Mode 1], turn on the power of the scanner. Then the LCD displays the SETUP MODE initial screen. (Screen 1)

2Press [Mode 1] eight times to go to the ENDORSER INITIAL screen. (Screen 2) Then press [Mode 2]. If “ON” is displayed, the endorser is already on. (Screen 3)

3If “OFF” is displayed, press [Mode 1], until “OFF” blinks. Then press [Mode 2] to turn the endorser ON. (Screen 3)

If you want to set the status in EEPROM, go to 5 . Then if you want to close the job, go to 6 and 7 .

NOTICE: Set the endorser ON only when you use endorser, or the

characters may be printed on every scanned document.

A2.2 How to set the initial number

Initial number is the number which the scanner starts printing or returns after the reset of print number.

ENDORSER VALUE

* ON

 

0

0 0 0 5

 

 

 

 

 

Screen 4

 

 

 

EEPROM WRITE?

 

(Mode 2 Write)

 

 

 

Screen 5

4At Screen 3, press the [Mode 1] until the digit you want to changes blinks. Then press [Mode 2] until the digit changes as you want. (Screen 4: In this case the initial number is five.)

5To set the status in EEPROM, press [Mode

1] until * blinks. Then press [Mode 2] to change the LCD display into Screen 5. If you want to set, press [Mode 2]. And the LCD displays Screen 6 about three seconds.

A-2

M3099EX/EH OEM Manual