Fujitsu M3099EX/EH manual 204

B3. Contents of the setup mode

The setup mode can be classified into seventeen:

Mode	Setup type	Contents
1	Setting double feed	Set in EEPROM whether double feed detection
	detection	is done or not.
2	Setting IPC-2	Set in EEPROM the pattern No. of IPC-2 pre-
	pre-set	set mode.
3	Reset of abrasion	Reset the abrasion counter after Belt/Roller are
	counter	exchanged.
4	Setting buzzer	Set in EEPROM whethr the buzzer function is
		on or off.
5	Setting pre-pick	Set in EEPROM whether pre-picking is done
		for fast reading or not.
6	Adjusting LCD	Set in EEPROM the LCD contrast.
	contrast
7	Setting pick speed	Set in EEPROM whether pick speed is fast or
		slow.
8	Setting initial value	Set the using of endorser and the initial
	of endorser	number. The set value is able to be stored in
	number	EEPROM.
9	Setting method of	Set in EEPROM whether the number is reset
	endorser reset	by hopper empty detection.
10	Reset of endorser	Reset the number to initial value.
	number
11	Reset of ink	Reset the ink counter after the print head has
	counter	be replaced.
12	Setting RS232C	Set in EEPROM the transfer rate. (1200/2400/
	transfer rate	4800/9600)
13	Setting picking	Set in EEPROM the time from when the
	start time	hopper empty sensor is blocked in manual mode
		until picking begins.
14	Setting picking	Set the time from when picking begins until the
	time	SF1 sensor is blocked by paper.
15	Setting time-out	Set the time from when a command is issued in
	limit	manual mode until paper is actually detected.
16	Setting hopper	Set the time from when Start Command
	time	Timeout limits until hopper table is lowered.
17	Setting heater	Set in EEPROM whether the heater control is
	control	on or off.

B-2 M3099EX/EH OEM Manual