B3.1 Setting double-feed detection

When you set the using of double-feed detection, you must set as follows.

<< SETUP MODE >>

DOUBLE FEED CHECK

Screen 3

DOUBLE FEED CHECK

OFF115mm

Screen 4

DOUBLE FEED CHECK

OFF115mm

Screen 5

DOUBLE FEED CHECK

OFF115mm

Screen 6

4At Screen 2, press [Mode 1] once to go to the DOUBLE FEED CHECK screen. (Screen 3)

5Press [Mode 2] to see Screen 4. If “ON” is displayed, the error will be detected when the double-feed is occured. If “OFF” is displayed, it wouldn’t. The “ON” or “OFF” status flips each time you press [Mode 2].

6Press [Mode 1] to see Screen 5. This means how to defect the double-feed as follows. “1” is the method by comparing with the length of the first paper.

“2” is the method by the output of Document detection sensor in addition to “1”.

At Screen 5, press the [Mode 2] until the number changes as you want.

7Press [Mode 1] to see Screen 6. This means the length to compare with the paper based on. If you choose “1” or “2” and set “15mm”, the double-feed is detected when the scanned

paper length is 15mm longer than the first

paper.SETUP MODE At Screen 6, press the [Mode 2] until the

number changes as you want.

(You can choose 10, 15 or 20mm. The default is 15mm.)

8Press [Mode 1] and [Mode 2] at a time to see Screen 3. The settings are stored to

EEPROM.

9When you close the setup mode, press [Stop]. Then the readable screen is displayed.

M3099EX/EH OEM Manual

B-3