EEPROM Writing!!

Screen 6

6If you want to return to the ENDORSER INITIAL screen (Screen 2), press [Mode 1] and [Mode 2] at a time.

7If you want to return to the initial status to read, press [STOP].

A2.3 How to set the print number reset condition

You can choose whether to reset or not when HOPPER EMPTY is detected.

<<SETUP MODE >> ENDORSER RESET METHOD

Screen 7

HOP-EMPTY RESET

ON

Screen 8

8At Screen 1 press [Mode 1] nine times to go to the ENDORSER RESET METHOD screen. (Screen 7)

9Press [Mode 2] to see Screen 8. If “ON” is displayed, the print number will be reset when HOPPER EMPTY is detected. If “OFF” is displayed, it wouldn’t. The “ON” or “OFF” status flips each time you press [Mode 1]. The status will be set in EEPROM automatically.

10If you want to return to Screen 7, press [Mode 2].

If you want to close the job, go to 7 .

ENDORSER

A2.4 How to reset the print number manually

You can reset the print number to the initial number by operator panel as follows.

<<SETUP MODE >> ENDORSER RESET

Screen 9

RESET

VALUE 0

0 0 0 1

No-Mode 1

Yes-Mode 2

 

 

 

 

 

Screen 10

 

11 At Screen 1 press [Mode 1] ten times to go to the ENDORSER RESET screen. (Screen 9)

12 Press [Mode 2] to see Screen 10. You may see current print number. If you want to reset the number, press [Mode 2]. And you can see Screen 11 for 3 sec. If you don’t want it, press [Mode 1] to go to Screen 9.

If you want to close the job, go to 7 .

RESET Finish !!

0 0 0 0 1

Screen 11

M3099EX/EH OEM Manual

A-3