CLEAR command

This command initializes the scanner and can be issued at any time.

b7b0 b7b0 b7b0

 

 

CNT

 

CMD

 

CLEAR

 

 

 

(X‘03’)

 

(X‘44’)

 

command

 

 

INTERFACE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SPECIFICATIONS

CLEAR command details

 

 

 

 

 

 

 

 

 

 

 

b7

 

 

 

 

 

b0

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

00:POWER ON CLEAR

This command resets the system to the power-on status.

01:Control register clear

This command intitializes the operation mode, image processing mode, and subwindow mode. (*1)

10:Reading stop

This command stops operation during (VGATE OFF, return) and ejects any documents remaining in the ADF.

If this command is received after the front- side is reading ends, the scanner is placed in wait state.

Note: "Ready" is the response when this command ends normally.

*1: If a CONTROL REGISTER CLEAR command is issued after the READ command is sent to the scanner but before the Read Complete

is recieved from the scanner, a command sequence error occur.

M3099EX/EH OEM Manual

3-19