Henny Penny 680 KFC manual Product One

Product One		Pressure	Solenoid
		and Neat	Control
Select Time		Product	Indicators
Select Function		Function	Indicators
Change Button		Change Button
Under Display	4	Indicator	Display
Change Button		Change Button
Under Display	3	Indicator	Display
Change Button		Change Button
Under Display	2	Indicator	Display
Change Button		Change Button
Under Display	1	Indicator	Display

The SELECT FUNCTION or SELECT TIME button must be depressed before the PRODUCT ONE button to properly perform the solenoid and heat control output test.

For short durati		perate without
temperature	regulation,	or will overheat the
shortening.

When programming one-step KFC parameters, load compen- sation and proportional control are automatically programmed into the control. The following defines these two functions.

-Load compensation adjusts cooking sate for differences in the cooking process such

as load size. The control is continuously comparing the pot temperature to the setpoint temperature. If the pot temperature is above the setpoint, the control will shorten the cook time. If the pot temperature is below the setpoint, the control will lengthen the cook time. Load compensation for KFC parameters is set at 0.

=Proportional control regulates pot the heat on and off until it reaches

setpoint temperature. This allows better temperature accuracy when dropping product. Proportional control for KFC parameters is set at 10 degrees.