| The ignitors are electrically energized and the tip of the ignitor |
| glows red creating combustion in the burner chamber. It then |
| sensesthe combustion and sends the message to the modules. |
| If no combustion occurs, the modules shut the gas off at the |
| gas valve. |
ee | When the Power/Pump switch is in the power position, a red |
| glow should be seen in each porthole in the front of the fryer. |
| If no red glow is seen, proceed with the following: |
| 1. Remove electrical power supplied to the unit. |
Remove electrical power supplied to the unit by unplug- ging the unit, or by turning off the wall circuit breaker, or electrical shock could result.
‘2. Remove the side panel.
3.Locate and remove the wire nuts on the leads to the ignitors.
4.The ignitor should ohm out at
The following checks are performed with the wall circuit breaker closed and the Power/Pump switch in the Power position. Extreme caution should be taken. Make connections before applying power, take reading, and remove power before removing meter leads, or electrical shock could result.
5.Also, a voltage check can be taken. The ignitor should receive 24 volts from the ignitor module. If 24 volts is found from the leads from the modules, then the ignitor is probably faulty.
If an ignitor is found to be faulty it must be replaced as follows:
1. Remove electrical power supplied to the unit.
Remove electrical power supplied to the unit by unplug- ging the unit, or by turning off the wall circuit breaker, or electrical shock could result.
2.emove the side panel.
