The ignitor module sends 24 volts to the ignitors and there is an ignitor module for each ignitor.
1. Remove electrical power supplied to the unit.
Remove electrical power supplied to the unit by unplug- ging the unit, or by turning off the wall circuit breaker, or electrical shock could result.
2.Remove small access panel from right side panel.
3.Remove wires from modules.
Mark wires before removal to insure new modules are wired correctly.
4.Remove the two nuts securing the module and remove module.
5.Install new module in reverse order.
Upon lifting up on the drain knob, the microswitch should not be activated, but still be activated by pulling out on the knob. The nuts on the microswitch can be screwed up or down to adjust the microswitch.
1.Remove electrical power supplied to the unit.
Remove electrical power supplied to the unit by unplug- ging the unit, or by turning off the wall circuit breaker, or electrical shock could result.
2.The following check should be made to determine if the Drain Switch is defective.
a.Remove the right side panel.
b.Remove bottom nut securing the microswitch and remove microswitch from unit.
