Honeywell 5820XL manual Followed by Installer or User Code or rotate Key

					System Operation
			Table 8-1: Operation Mode Behavior
Operation	Occurs When		System Behavior		In This Mode You Can
Mode
Prealarm	A single detector	Touchpad PZT beeps.		Press	(down arrow) to view the prealarm. A
	trips in a 2-	The LCD displays a screen similar to this
				screen similar to this one displays.
	Count zone. (2-
		one.
	Count means
	two detectors
	must trip before
	an alarm is
	reported.)

					All system operations are available in this mode.
Reset				All LEDs are on briefly then the LCD	Menus are not available during the reset process.
	The		RESET
				displays "ALARM RESET IN
	button is pressed
	followed by a			PROGRESS". If the reset process
				completes normally, the date and time
	valid code or
				normal mode screen displays.
	rotation of the
	key.
Silenced	An alarm or			SYSTEM SILENCE LED is on. SYSTEM	Press	(down arrow) to view the location of the
	trouble			TROUBLE, SUPERVISORY or	alarm or trouble. When the condition no longer
	condition has			GENERAL ALARM LED (depending on
					exists, the SYSTEM SILENCED and SYSTEM
	been silenced			condition) is on. The annunciator (and any
					TROUBLE LED, SUPERVISORY or GENERAL
	but still exists.			notification devices attached to the	ALARM LEDs turn off.
	To silence			system) will be silenced.
	alarms and
	troubles, press
		SILENCE
	followed by the
	Installer or User
	Code or rotate
	the key.

151209 8-13