Honeywell 5820XL manual Class a Inputs, Class a initiating Switches

IntelliKnight 5820XL Installation Manual

4.13.2.2 Class A Inputs

You can connect conventional Class A switches, such as waterflow switches and pull stations, directly to the Flexput circuits of the control panel.

To install a Class A switch:

1.Wire the Class A switch as shown in Figure 4-33.

2.Configure the circuit through programming (see Section 7.6).

Supervised

Power Limited

Note:

Flexput circuit 5 and 6 used as an example. Any Flexput point pairing could be used.

Figure 4-33 Class A initiating Switches

Note: In programming any point that uses multiple Flexput circuits, the lowest Flexput circuit number is used to refer to the circuit pair. For example, Figure 4-33uses both Flexput circuit 5 and 6, so in programming it would be referred to as point 5.

4-34 151209