IntelliKnight 5820XL Installation Manual
4.After the annunciator wiring to the panel has been completed (described in Section 4.5.2), replace the electronic assembly in the back box. Place the bezel over the back box and tighten the set screws on the bezel.
Figure 4-13 Flush Mounting the Back Box
4.5.1.2 Surface Mounting
The 5860 can be mounted directly to a surface or can be attached to a single, double, or four- square electrical box. The Model 5860TG/TR trim ring kit is available for use when surface mounting.
1.Drill holes in the surface to match the screw holes on the back box.
2.Fit the trim ring over the back box.
3.Attach the back box to the surface using screws provided.
4.After the annunciator wiring to the panel has been completed (described in Section 4.5.2), replace the electronic assembly in the back box. Place the bezel over the back box and tighten the set screws on the bezel.
151209 |
