HP 8360 Menu Map, See Also, CONNECTORS, Description, Function Group, Programming Codes, RF Output Connector, C-12Operating and Programming Reference

CONNECTORS

RF Output Connector The synthesizer is equipped with a precision 3.5 mm male connector (2.4 mm male connector on 40 GHz models). The output impedance, SWR and other electrical characteristics are listed in “Specifications”. When making connections, carefully align the center conductor elements, then rotate the knurled barrel while the mating component remains still. Tighten until firm contact is made.

Take care when working with either of these connectors. If this connector is mechanically degraded in any way, high frequency losses occur. Refer to Application Note 326, Connector Cure, for more information.

(CONT)

Function Group

Menu Map

Description

SWEEP

7

This hardkey initiates continuous sweep-retrace cycling of the synthesizer. The sweep is initiated by one of the trigger functions, while the sweep speed is controlled by the sweep time function. The green LED located above this key lights when the synthesizer is performing an list, step, or analog sweep. The LED is off during all of the following: retrace, band crossings, phase locking at the start frequency of each new sweep and during manual sweeps.

Programming Codes

See Also

SCPI: 1NITiate:CONTinuous ON/l

Analyzer: Sl

Manual Sweep, [SINGLE)

“Continuous, Single, and Manual Sweep Operation” in Chapter 1. “Programming Typical Measurements” in Chapter 1.

C-12 Operating and Programming Reference	HP 8360
	User’s Handbook