HP 8360 manual Bnc

	SCPI COMMAND SUMMARY
MARKer[n]:MODE	How the frequency of the marker is determined.
FREQuency	Absolute frequency is used. The limits are
	confined to the present START and STOP
	frequency limits.
DELTa	The value is specified with respect to the
	reference marker. (MARKer[n]:REFerence)

The *RST values are the same as the FREQ : CENTcommand *RST value.

•MARKer EnI : MODE FREQuency I DELTa

•MARKer [n] : MODE?

Sets and queries the mode of the specified marker. Setting one marker to delta turns all other marker modes to frequency. If [n] is not specified, the default is one. *RST value is FREQuency.

•MARKer [n] : REFerence <r-r>

•MARKer [nl : REFerence?

Sets and queries which marker is the reference marker for use in the delta mode. While [n] may be used, there is really only a single reference for all the markers. MARKerl :REFerence 5; and MARKer2:REFerence 5; both set marker 5 as the reference.

•MARKer [n] [ : STATeI ON OFF 1 O

•MARKer [n] [ : STATe] ?

The state of the specified marker is set and queried (marker number one if [n] is not specified). The *RST value for all markers is OFF.

•MEASure : AM?

A query-only command that causes the modulating AM signal to be measured and the absolute value of the peak percent deviation to be returned.

a MEASure : FM

A query-only command that causes the modulating FM signal level to be measured and the corresponding peak frequency deviation returned.

•MODulation:OUTPut:SOURceAMIFM

•MODulation:OUTPut:SOURce?

Sets and queries the source of the rear panel output modulation

BNC.

•MODulation:OUTPut:STATe ONlOFFlllO

•MODulation:OUTPut:STATe?

Sets and queries the state of the rear panel output modulation BNC.

HP 8360	Operating and Programming Reference S-41
User’s Handbook