HP 8360 User’s Handbook, SCPI COMMAND SUMMARY, Operating and Programming Reference S-55

HP 8360

User’s Handbook

SCPI COMMAND SUMMARY

is not affected by *RST. When you change the value from ON to OFF, everything except calibration data is initialized or destroyed. In particular, data in instrument state and all save/recall registers are destroyed.

•SYSTem:VERSion?

This query returns a formatted numeric value corresponding to the SCPI version number to which the synthesizer complies. The response has the form YYYY.V where the Ys represent the year version (i.e. 1990) and the V represents an approved revision number for that year. This is a query only and therefore does not have an associated *RST state.

•TRIGger[:IMMediate]

Causes the trigger event to occur regardless of other settings in the subsystem. This event does not affect any other settings in this subsystem.

This command has no effect unless the synthesizer is in the wait for trig state. If the synthesizer is in the wait for trig state, it performs its trigger action. This is an event and has no “RST condition.

•TRIGger:ODELay <num>[time suffix] IMAXimumlMINimum

•TRIGger:ODELay.7 [MAXimumlMINimum]

Sets and queries the trigger output delay, the time between when the source is settled, (when Bit 1 of the Standard Operation Status

Register makes a negative transition), and the trigger out signal is sent.

•TRIGger:SOURce IMMediatelBUSIEXTernal

•TRIGger:SOURce?

Sets and queries the source of the trigger event.

a TSWeep

This is a convenience command that does the equivalent of

ABORt;INITiate[:IMMediate]

•UNIT:AM DBIPCT

•UNIT:AM?

Sets and queries the default units for AM depth.

The *RST value is PCT.

•UNIT:POWer [lvl suffix]

•UNIT:POWer?

Sets and queries the default power subsystem units. *RST value is DBM.

Operating and Programming Reference S-55