HP 8360 manual Frequency Subsystem

SCPI COMMAND SUMMARY

positions to the bandwidth, < 20 Hz and > 100 kHz, but any numeric is accepted. The value is compared to 1 kHz and the correct position is determined (> 1 kHz sets the position to 100 kHz and

5 1 kHz sets the position to 20 Hz). After *RST, the value is 100 kHz.

•FM:INTernal:FREQuency <num>[freq suffix] IMAXimumlMINimum

•FM:INTernal:FREQuency? [MAXimumlMINimum]

Sets and queries the frequency (in Hz) of the internal FM source.

After *RST, the value is 1 MHz.

•FM:INTernal:FUNCtion SINusoid~SQUarelTRIagleiRAMPlNOISe

•FM:INTernal:FUNCtion?

Sets and queries the waveform of the internal FM source.

After “RST, the value is SINusoid.

•FM:SOURce INTernallEXTernal

•FM:SOURce?

Sets and queries the source of the FM modulating signal.

After *RST, the value is EXTernal.

•FM:SENSitivity <num>[freq suffix/V] lMAXimumlMINimum

•FM:SENSitivity? CMAXimumIMINimum]

Sets and queries the FM Input sensitivity.

The *RST value is MAX (10 MHz/V) .

•FM:STATe ONlOFFlllO

•FM:STATe?

Sets and queries the FM modulation state.

After *RST, the value is OFF.

Frequency Subsystem	Any two frequency setting headers (STARt, STOP, CENTer, or
	SPAN) may be sent in a single message and the resulting sweep
	is what was requested. The order of the headers in the message
	does not make any difference in the final result. When a message is
	completed, coupling equations are used to fix the unset parameters to
	the correct values. These equations specify that:
	center frequency = (start + stop) / 2
	frequency span = (stop - start)
	If more than two are sent then the last two in the message are used
	to determine the sweep and no errors are given.
	If only one header is sent in a message, then the assumed pairs are
	center/span and start/stop. In other words, if only center is sent,
	then span is kept constant (if possible) while adjusting center to the
	requested value. The start/stop frequencies are updated to reflect the
	changes based on the coupling equations.
HP 8360	Operating and Programming Reference S-35
User’s Handbook