List Menu

To remove a frequency point and its associated offset value and dwell time, use the delete menu \(Delete current ) softkey. To remove an entire frequency list, use the delete me!nu, (Delete All ) softkey.

Editing ALC Offset and Dwell Time

Once a frequency point has been entered, You can assign an ALC offset and a dwell time value. Use either the Enter List Power

or Global Offset softkey to enter offset values. Use either the

Enter List Dwell or Global Dwell. softkey to enter dwell time values.

The editing softkeys of this menu are not accessible over HP-IB. Frequency lists to be loaded over HP-IB must first be created in the controlling program and then downloaded in their entirety to the synthesizer.

Programming Codes SCPI:

LIST:FREQuency {<num>[freq suffix](MAXimum(MINimum}

LIST:[POWer]:CORRection {<num>[DB]JMAXimum]MINimum}

LIST:DWELl {<num>[time suffix]]MAXimum(MINimum}

In the above three commands, the entries contained in {} can be repeated between 1 to 801 times.

LIST:DWELl:POINts? [MAXimumlMINimum] LIST:FREQuency:POINts? [MAXimum(MINimum] LIST[:POWer]:CORRection:POINts? [MAXimumlMINimum]

In the above three commands, the synthesizer responds with the number of points for the named parameter that are in the list array.

If a particular list is shorter than another, an error is generated upon execution. An exception is made for the case where the shorter list is of length 1. In this case, the list of length 1 is treated as though it were a list of equal length, with all values the same. At *RST, all lists for the current state are cleared and reset to a single value.

Analyzer: NONE

See Also [m), (SAVE), Sweep Mode List

“Creating and Using a Frequency List,” in Chapter 1.

HP 8360

Operating and Programming Reference L-7

User’s Handbook