
10 MHz Reference Input
Accepts 10 MHz flO0 Hz, 0 to +lO dBm reference signal for operation from external time base. Nominal input impedance 50 ohms. Damage level +lO,
10 MHz Reference Output
Nominal signal level 0 dBm, nominal output impedance 50 ohms. (BNC female, rear panel.)
Sweep Output
Supplies a voltage proportional to the sweep ranging from 0 volts at start of sweep to +lO volts at end of sweep, regardless of sweep width. In CW mode, voltage is proportional to percentage of full instrument frequency range. Minimum load impedance 3 kilohms. Accuracy *0.25%, 310 mV, typical. (BNC female, rear panel.)
Stop Sweep Input/Output
Sweep will stop when grounded externally.
Z-Axis Blanking/Markers Output
Supplies positive rectangular pulse (Approximately +5 volts into
2 k0) during the retrace and bandswitch points of the RF output. Also supplies a negative pulse
Volts/GHz Output
Supplies voltage proportional to output frequency at 0.5 volts/GHz (internally switchable to 0.25 or 1 volt/GHz). Maximum output 18 volts. Minimum load impedance 2 kR. Accuracy f0.5%, f10 mV, typical. (BNC female, rear panel.)
Source Module Interface
Provides bias, flatness correction, and leveling connections to
HP
Auxiliary Interface
Provides control signal connections to HP 8516A
Pulse Video Output (Option 002 only)
Outputs the pulse modulation waveform that is supplied to the modulator. This can be either the internally or externally generated pulse modulation signal. (BNC female, rear panel.)
| Specifications |