Add-On Devices

Installing Additional RAM

Installing Additional RAM

 

 

The computer has no memory (RAM) built in but has two slots that hold two RAM

 

 

modules. At least one slot contains a RAM module installed at the factory. You can use

 

 

both slots to expand your RAM.

 

 

 

 

 

To install a RAM expansion module

 

 

Use HP PC2100 DDR-266 or higher RAM only.

 

 

You’ll need a small Phillips screwdriver for these steps.

 

 

 

CAUTION

Your computer’s chips are extremely sensitive to static electricity, and can be

 

 

permanently damaged by it. Handle the RAM module only by its edges. Before

 

 

installing the memory module, discharge your body’s static electricity by touching

 

 

the metal shielding around the connectors on the back of the computer.

 

 

1.

Click Start, Turn Off Computer, Turn Off.

 

 

 

 

2.

Important: unplug the AC adapter, if present, and remove the battery.

 

 

3.

Turn the unit bottom-side up, loosen the screws holding the RAM cover, and remove

 

 

 

the cover.

 

 

4.

Insert the RAM board into the connector at about a 30° angle until it is fully inserted.

 

 

 

Then press down at both sides until both latches snap closed.

5.Replace the cover.

6.Insert the battery.

Reference Guide

89