HP Enterprise File Services WAN Accelerator manual To set a static main route

To set a static main route

1.Click the Setup tab to display the Setup menu.

2.Click Host Settings to expand the Host Settings menu.

3.Click Routing: Main to display Host Settings - Routing: Main page.

Figure 2-18.Host Settings - Routing: Main Page

	4. Use the controls to complete the configuration, as described in the following table.
Control		Description
Add New Route		Destination. Specify the IP address.
		Netmask. Specify the subnet mask.
		Gateway. Specify the IP address for the gateway. The gateway must be in the same
		network as the primary or auxiliary interface.
		Add Route. Specify this option to add the entry to the list.
		Remove Selected Routes. To remove an entry, click the check box next to the entry and
		click Remove Selected Routes.

Setting Static In-Path Routes

5.Click Save to save your settings permanently or click Reset to return the settings to their previous values.

You configure static, in-path network routes if your network configuration requires additional static in-path network routing rules in the Host Settings - Routing: In-Path page.

The values you specify set the routing table for in-path interfaces (as opposed to the primary interface).

60 CONFIGURING THE HP EFS WAN ACCELERATOR