HP Enterprise File Services WAN Accelerator Setting Alarm Parameters, To set alarm parameters

Setting Alarm Parameters

To set alarm parameters

You can set alarms in Reports - Alarm Settings page.

Enabling alarms is optional.

1.Click the Setup tab to display the Setup menu.

2.Click Reports to display the Reports - Alarm Settings page.

Figure 2-47.Reports - Alarm Settings Page

3.Use the controls to complete the configuration, as described in the following table.

Control	Description
CPU Alarms	Raise Alarm When CPU Utilization Reaches. Specify this option to trigger an alarm if
	the average and peak threshold for the Central Processing Unit (CPU) utilization is
	exceeded. When an alarm reaches the rising threshold, it is activated; when it reaches the
	lowest or reset threshold, it is reset. After an alarm is triggered, it is not triggered again
	until it has fallen below the reset threshold.
	This alarm is enabled by default, with a rising threshold of 90% and a reset threshold of
	70%.
	Rising Threshold. Specify rising value CPU utilization.
	Reset Threshold. Specify reset value for CPU utilization.
Data Store Alarm	Send email if stale data replaced by fresh data is less than __ day(s) old. Specify this
	option to trigger an alarm if data in the data store is replaced with new data before the
	time period specified.

116 CONFIGURING THE HP EFS WAN ACCELERATOR