HP Integrity Server rx4640 manual 102

Removing and Replacing Components

Removing and Replacing the DVD Drive

Removing and Replacing the DVD Drive

These procedures show how to remove and replace the DVD drive. The DVD drive is located on the front of the HP server.

WARNING Ensure that the server is powered down and all power sources have been disconnected from the server prior to removing or replacing a DVD drive.

Voltages are present at various locations within the server whenever an ac power source is connected. This voltage is present even when the main power switch is in the off position.

Failure to observe this warning could result in personal injury or damage to equipment.

CAUTION Failure to properly complete the steps in this procedure will result in erratic server behavior or server failure. For assistance with this procedure contact your local HP Authorized Service Provider.

Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety precautions could result in damage to the server.

Removing the DVD Drive

To remove a DVD drive, follow these steps:

Step	1.	Grasp the front of the DVD drive and squeeze in on the locking tab to release the drive.
Step	2.	Remove the front bezel. See “Removing the Front Bezel” on page 41.

102 Chapter 4