HP Integrity Server rx4640 Extending the Server from the Rack, Inserting the Server into the Rack

Removing and Replacing Components

Accessing a Rack Mounted Server

Extending the Server from the Rack

NOTE	Ensure that there is enough area (Approximately 1.5 meters [4.5 ft.]) to fully extend the server
	out the front and work on it.

To extend the server from the rack, follow these steps:

Step	1.	Remove the T-25 screws that fasten the server to the rack. See Figure 4-1, “Accessing 25MM Torx
		Screws.”
Step	2.	Flip out the two pull handles at either end of the front bezel and slowly pull the unit forward by the
		handles. The server is fully extended when the rail clips are locked in place. When fully extended,
		the front and top covers are fully accessible.

Figure 4-1 Accessing 25MM Torx Screws

25MM Torx screw 2X

Inserting the Server into the Rack

To insert the server into the rack, follow these steps:

Step	1.	Press the rail clips on either side of the server inward and push the server into the rack until it
		stops.
Step	2.	Replace the T-25 screws that fasten the server to the rack.

Chapter 4 39