HP Integrity Server rx4640 Removing and Replacing the Display Board, Removing the Display Board

Removing and Replacing Components

Removing and Replacing the Display Board

Removing and Replacing the Display Board

These procedures detail how to remove and replace the display board. The display board is located behind the control panel and under the front cover. The display board contains the server’s on/off switch and three LEDs that indicate server status.

WARNING Ensure that the server is powered down and all power sources have been disconnected from the server prior to removing or replacing the display board.

Voltages are present at various locations within the server whenever an ac power source is connected. This voltage is present even when the main power switch is in the off position.

Failure to observe this warning could result in personal injury or damage to equipment.

CAUTION Failure to properly complete the steps in this procedure will result in erratic server behavior or server failure. For assistance with this procedure contact your local HP Authorized Service Provider.

Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety precautions could result in damage to the server.

Removing the Display Board

To remove the display board, follow these steps:

Step	1.	If rack mounted, slide the HP server out from the rack until it stops. See “Extending the Server
		from the Rack” on page 39.
Step	2.	Remove the front bezel. See “Removing the Front Bezel” on page 41.
Step	3.	Remove the front cover. See “Removing the Front Cover” on page 42.
Step	4.	Using your finger, slightly pull out the retaining tab on the chassis that holds the display board in
		position.

Chapter 4 107