Removing and Replacing Components

Removing and Replacing Hot-Plug PCI-X Cards

Slots 7 and 8 are single slots, they do not share a PCI-X bus. The maximum capability of each slot is PCI-X 133 MHz. Only slots 7 and 8 allow 133 Mhz, PCI-X cards to run at full speed. These two slots are not limited by bus mode frequency related incompatibilities.

Table 4-8

PCI-X Card vs. Slot Frequency/Bus Mode Compatibility for Shared

 

Slotsa

 

 

 

 

 

 

 

 

 

 

 

Current PCI Bus

 

 

Cards to be installed

 

 

Mode and

 

 

 

 

 

 

 

 

 

 

 

 

Frequency for

 

PCI 33

PCI 66

PCI-X 66

PCI-X 133

 

the Shared Slot

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PCI 33 MHz

 

Compatibleb

Compatible

Compatible

Compatible

 

 

 

 

(note b)

(note b)

(note b)

 

 

 

 

New card

New card

New card

 

 

 

 

running at

running at

running at

 

 

 

 

PCI 33

PCI 33

PCI 33

 

 

 

 

 

 

 

 

PCI 66 MHz

 

Incompatible

Compatible

Compatible

Compatible

 

 

 

-Frequencyc

(note b)

(note b)

(note b)

 

 

 

 

 

New card

New card

 

 

 

 

 

running at

running at

 

 

 

 

 

PCI 66

PCI 66

 

 

 

 

 

 

 

 

PCI-X 66 MHz

 

Incompatible

Incompatible-

Compatible

Compatible

 

 

 

-Frequency

Busd

(note b)

(note b)

 

 

 

(note c)

 

 

New card

 

 

 

 

 

 

running at

 

 

 

 

 

 

PCI-X 66

 

 

 

 

 

 

 

 

PCI-X 133 MHze

 

Incompatible

Incompatible-

Compatible

Compatible

 

 

 

-Frequency

Frequency

(note b)

(note b)

 

 

 

(note c)

(note c)

New card

New card

 

 

 

 

 

 

running at

 

 

 

 

 

 

PCI-X 66

 

 

 

 

 

 

 

 

a.The conditions described in this table apply only to shared slots (slots 3,4-bus 2 and 5,6-bus 3). Slots 7 and 8 are not shared slots.

b.Compatible: card is accepted and runs at frequency shown.

c.Incompatible-Frequency: card is rejected. The new card will not initialized and will power down due to frequency mismatch.

d.Incompatible-Bus: Card is rejected. The new card will not initialize and will power down due to bus mode mismatch.

e.Maximum bus mode and frequency supported on shared slots is PCI-X 66 MHz.

CAUTION If you are using Linux Red Hat Enterprise Advanced Server 4 Update 3 operating system and you want to install a 1000b-Sx GigE card, do not install it into a slot that shares a bus with a 33 MHz card. In this configuration the Linux driver will not initialize the new card.

Chapter 4

75

Page 75
Image 75
HP Integrity Server rx4640 manual Slots a, PCI 66 MHz, PCI-X 66 MHz, PCI-X 133 MHz e