HP Integrity Server rx4640 manual Removing and Replacing the LAN Core I/O Card

Removing and Replacing Components

Removing and Replacing Core I/O Cards

Removing and Replacing the LAN Core I/O Card

Removing the LAN Core I/O Card

To remove the LAN core I/O card in slot 2, follow these steps:

Step	1.	If rack mounted, slide the HP server out from the rack until it stops. See “Extending the Server
		from the Rack” on page 39.
Step	2.	Remove the top cover from the chassis. See “Removing the Top Cover” on page 43.
Step	3.	Disconnect any LAN cables connected to the LAN core I/O card.
Step	4.	Open the blue PCI card latch for slot 2 by twisting it clockwise.

Figure 4-33 LAN I/O Card Latch Location

LAN PCI I/O card latch for slot 2 (closed)

LAN PCI Card

Step	5.	Remove LAN I/O card by pulling up carefully on the LAN I/O card.
Step	6.	Install replacement LAN I/O card. Figure 4-32 shows how to install the LAN I/O card correctly.
		CAUTION	Always handle I/O cards by their edges. Failure to comply with this precaution may
			result in damage to the card.
			Ensure that you fully seat the card into the slot or the card may be damaged when
			power is re-applied to the slot.
Step	7.	Close the blue PCI card latch for slot 2 by twisting it counter-clockwise.
Step	8.	Reconnect the LAN cable(s) to the LAN core I/O card.
Step	9.	Replace the top cover. “Replacing the Top Cover” on page 44.

Step 10. Push the HP server back into the rack until it stops. “Inserting the Server into the Rack” on page 39.

88 Chapter 4