HP Integrity Server rx4640 manual Removing a Processor

Removing and Replacing Components

Removing and Replacing a Processor

Figure 4-13 Processor Slot Locations on the Processor Extender Board

CPU 1

CPU 0

CPU 3 (under)

CPU 2 (under

Removing a Processor

To remove a processor on the processor extender board, follow these steps:

NOTE		The processor being removed in this procedure is CPU 1. This procedure applies to all the
		processors on the processor extender board.
Step	1.	If rack mounted, slide the HP server out from the rack until it stops. See “Extending the Server
		from the Rack” on page 39.
Step	2.	Remove the front bezel. See “Removing the Front Bezel” on page 41.
Step	3.	Remove the front cover. See “Removing the Front Cover” on page 42.
Step	4.	Remove the processor extender board. See “Removing the Processor Extender Board” on page 52.

56 Chapter 4