4Removing and Replacing Components

This chapter describes the procedure for removing and replacing the different components in the HP Integrity rx4640 server.

This chapter addresses the following topics:

•“Safety Information” on page 38

•“Service Tools Required” on page 38

•“Accessing a Rack Mounted Server” on page 38

•“Accessing a Pedestal Mounted Server” on page 40

•“Removing and Replacing the Front Bezel” on page 41

•“Removing and Replacing the Front and Top Covers” on page 42

•“Removing and Replacing the Memory Extender Board” on page 44

•“Removing and Replacing Server Memory DIMMs” on page 46

•“Removing and Replacing the Processor Extender Board” on page 52

•“Removing and Replacing a Processor” on page 55

•“Removing and Replacing Hot-Swap Chassis Fans” on page 63

•“Removing and Replacing the I/O Baseboard” on page 66

•“Removing and Replacing Hot-PlugPCI-X Cards” on page 71

•“Removing and Replacing OLX Dividers” on page 81

•“Removing and Replacing Core I/O Cards” on page 85

•“Removing and Replacing the Server Battery” on page 89

•“Removing and Replacing Hard Disk Drives” on page 90

•“Removing and Replacing the SCSI Backplane Board” on page 93

•“Removing and Replacing the Midplane Riser Board” on page 95

•“Removing and Replacing the Power Supplies” on page 98

•“Removing and Replacing the Power Distribution Board” on page 100

•“Removing and Replacing the DVD Drive” on page 102

•“Removing and Replacing the DVD I/O Board” on page 104

•“Removing and Replacing the Display Board” on page 107

•“Removing and Replacing the QuickFind Diagnostic Board” on page 109

Chapter 4

37