HP Integrity Server rx4640 manual Removing and Replacing the Front and Top Covers

Removing and Replacing Components

Removing and Replacing the Front and Top Covers

Removing and Replacing the Front and Top Covers

The following procedures detail how to remove and replace the front and top covers of the HP Integrity rx4640 server. Figure 4-4 shows how to remove the front cover.

NOTE	When the front or top cover is removed the chassis fan units increase to high speed to assist
	cooling. When the top cover is replaced at the end of the operation, the chassis fans return to
	normal speed.

Figure 4-4 Removing and Replacing the Front Cover

Slots

Slots

Thumbscrews

Removing the Front Cover

To remove the front cover, follow these steps:

Step	1.	If rack mounted, slide the HP server out from the rack until it stops. See “Extending the Server
		from the Rack” on page 39.
Step	2.	Remove the front bezel. See “Removing the Front Bezel” on page 41.
Step	3.	Using a torx T15 driver, loosen the four captive thumbscrews that hold the front cover in place.
Step	4.	Raise the cover slightly, and pull the cover toward the front of the server to free the tabs from the
		slots in the chassis.

42 Chapter 4