Message

Explanation or recommended action

 

 

22 EIO x

Too much data was sent to the EIO card in the specified slot (x). An improper

BUFFER OVERFLOW

communications protocol might be in use.

To continue press

Press

to print the transferred data. (Some data might be lost.)

 

Check the host configuration. If this message persists, contact an

 

HP-authorized service or support provider. (See the HP support flyer or go to

 

www.hp.com/support/lj9050_lj9040.)

 

 

22 EMBEDDED I/O

Too much data was sent to the embedded HP Jetdirect print server.

BUFFER OVERFLOW

 

 

To continue press

 

 

 

 

 

22 PARALLEL I/O

BUFFER OVERFLOW

For help press

alternates with

To continue press

Too much data was sent to the parallel port.

Check for a loose cable connection, and be sure to use a high-quality cable. (See the HP support flyer or go to www.hp.com/support/lj9050_lj9040.) Some non-HP parallel cables might be missing pin connections or might otherwise not conform to the IEEE-1284 specification.

This error can occur if the driver you are using is not IEEE-1284 compliant. For best results, use the HP driver that came with the printer (see Printer drivers).

Press to clear the error message. (Data will be lost.)

If this message persists, contact an HP-authorized service or support provider. (See the HP support flyer or go to www.hp.com/support/lj9050_lj9040.)

40

EIO x BAD

The connection between the printer and the EIO card in the specified slot has

TRANSMISSION

been broken.

To continue press

Press

to clear the error message and continue printing.

 

 

40 EMBEDDED I/O BAD

The connection with the embedded HP Jetdirect print server has been broken.

TRANSMISSION

Turn the printer off, and then turn the printer on.

 

 

To continue press

 

 

 

 

41.x ERROR

A temporary printing error occurred.

For help press

Turn the printer off, and then turn the printer on.

alternates with

If this message persists, contact an HP-authorized service or support provider.

To continue press

(See the HP support flyer or go to www.hp.com/support/lj9050_lj9040.)

 

 

 

 

41.3UNEXPECTED SIZE IN TRAY xx

For help press

alternates with

To use another tray press

A tray (xx) is loaded with paper that is longer or shorter in the feed direction than the size configured for the tray.

Press to get to TRAY xx SIZE=. Reconfigure the size in a tray so the printer will use a tray that contains the size that is required for the print job.

If the error does not clear, turn the printer off, and then turn the printer on.

If this message persists, contact an HP-authorized service or support provider. (See the HP support flyer or go to www.hp.com/support/lj9050_lj9040.)

49.xxxxx ERROR

To continue turn off then on

A critical firmware error has occurred.

Turn the printer off, and then turn the printer on.

If this message persists, contact an HP-authorized service or support provider. (See the HP support flyer or go to www.hp.com/support/lj9050_lj9040.)

124 Chapter 6 Problem solving

ENWW