Setting the registration

Use the Set Registration feature to center the front and back images on a page that has been duplexed (printed on both sides). This feature also helps you set edge-to-edge printing to within approximately 2 millimeters (0.1 inch) of all edges of the paper. Image placement will vary slightly for each input tray. The alignment procedure must be performed for each tray. The administrator can use an internal-tray registration page to calibrate each tray.

To set the registration

1Press to open the menus.

2Use and to scroll to CONFIGURE DEVICE and then press .

3Use and to scroll to PRINT QUALITY and then press .

4Use and to scroll to SET REGISTRATION and then press .

You can select a tray by specifying a SOURCE. The default SOURCE is tray 2. If you want to set the registration for tray 2, go to step 7. Otherwise, proceed to the next step.

5Use and to scroll to SOURCE and then press .

6Use and to select a tray and then press . After selecting a tray, the control-panel display returns to the SET REGISTRATION menu.

7Use and to scroll to PRINT TEST PAGE and then press .

8Follow the instructions on the printed page.

ENWW

Setting the registration 75