Using the optional multifunction finisher
See the HP LaserJet 9040/9050 Getting Started Guide at www.hp.com/support/lj9050_lj9040 for more information about the following topics:
●Stapling documents
●Saddle stitching
●Printing booklets
●Adding a cover to a booklet
Output features
The optional multifunction finisher provides the following output features:
●Stacks up to 1,000 sheets of A4- and
●Stacks up to 50 booklets of 5 sheets of A3- and
●Offsets jobs
●Staples up to 50 sheets of paper per document of A4- and
●Staples up to 25 sheets of paper per document A3- and
●Folds single pages
●
Using the stapler
The finisher can staple documents consisting of a minimum of two pages, and a maximum of
50pages of 75 g/m2 (20 lb) A4- or
53lb) for any size supported by the product.
Consider these additional points:
●The stacker can hold up to 1,000 sheets stacked (not stapled).
●Heavier media might have a stapling limit of fewer than 50 pages.
If the job you want stapled consists of only one sheet, or if it consists of more than 50 sheets, the finisher delivers the job to the output bin without staples.
Selecting stapling
You can usually select the stapler through your program or driver, although some options might be available only through the driver. Where and how you make selections depends on your program or driver.
If you cannot select the stapler from the program or driver, select the stapler from the product control panel.
1Press to open the menus.
2Use and to scroll to CONFIGURE DEVICE and then press .
3Use and to scroll to STAPLES and then press .
4Use and to scroll to the desired stapling option and then press . Your stapling options are None, One, or Two staples.
ENWW | Using the optional multifunction finisher 63 |