Item | Options | Values | Explanation |
DIAGNOSTICS LOOPBACK TEST
PING TEST
PING
RESULTS
YES
NO
DEST IP
PACKET
SIZE
TIMEOUT
COUNT
RESULTS
EXECUTE
PACKETS SENT
PACKETS RECEIVED
PERCENT LOST
RTT MIN
RTT MAX
RTT AVE
PING IN PROGRESS
REFRESH
CAUTION This test will erase your TCP/IP configuration.
YES the loopback test will be initiated. NO the loopback test will not be initiated.
Specify the IP address of the remote host. A valid IP address must be entered.
Specify the size of each packet, in bytes, to be sent to the remote host. The minimum is 64 (default) and the maximum is 2048.
Specify the length of time, in seconds, to wait for a response from the remote host. The default is 1 and the maximum is 100.
Specify the number of pint test packets to send for this test. Select a value from 1 to 100. To configure the test to run continuously, select 0.
If the ping test was not set for continuous operation, you can choose to print the test results. YES to print results, NO to skip.
Specify whether to initiate the ping test. Select YES to initiate, NO to skip.
Determines the number of packets
Displays the number of packets
Displays the percent of ping test packets that wee sent with no response from the remote host since the most recent test was initiated or completed.
Displays the minimum detected
Displays the maximum detected RTT, from 0 to 4096 milliseconds, for packet transmission and response.
Displays the average detected RTT, from 0 to 4096 milliseconds, for packet transmission and response.
Displays whether or not a ping test is in progress. YES indicates a test in progress, NO indicates that a test completed or was not run.
Updates the ping test data with current results.
178 Appendix B | ENWW |