4.Connect the network cable to the EIO card.

5.Turn on the device, and then print a configuration page to verify that the new EIO device is recognized. See Use information pages.

NOTE When you print a configuration page, an HP Jetdirect configuration page that contains network configuration and status information also prints.

Remove an HP Jetdirect print server card

1.Turn off the device.

2.Disconnect the network cable from the EIO card.

3.Loosen the two screws from the EIO card, and then remove the EIO card from the EIO slot.

4.Place the cover plate from the EIO slot onto the back of the device. Insert and tighten the two screws.

5.Turn on the device.

240 Appendix E Working with memory and print server cards

ENWW