Initial Setup menu

The Initial Setup menu contains the sub-menus shown:

●Networking and I/O menu

●Fax Setup menu

●E-mail Setup menu

NOTE Values shown with "(default)" are the factory-default values. Some menu items have no default.

Networking and I/O

Table 2-9Networking and I/O

Menu item

Sub-menu item

Values

Description

 

 

 

 

I/O Timeout

Select a value in the

 

range. The factory default

 

setting is 15 seconds.

I/O timeout refers to the elapsed time before a print job fails. If the stream of data that the device receives for a print job gets interrupted, this setting indicates how long the device will wait before it reports that the job has failed.

Parallel Input

 

High Speed

No

Use the High Speed setting to configure the speed that

 

 

 

 

 

 

 

Yes (default)

the parallel port uses to communicate with the host.

 

 

 

 

NOTE This

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

item appears

 

Advanced Functions

Enabled (default)

Use the Advanced Functions setting to enable or

 

 

 

 

 

 

 

 

only if an EIO

 

 

 

 

 

 

 

 

disable bidirectional parallel communication.

 

 

 

 

accessory is

 

 

Disabled

 

 

 

 

 

 

 

 

 

 

 

installed.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Embedded Jetdirect

 

See Table 2-10 Jetdirect menus for the list of options.

 

 

 

 

 

 

EIO <X> Jetdirect

 

 

 

 

 

 

 

 

 

 

 

 

 

Table 2-10Jetdirect menus

Menu item

Sub-menu item

Sub-menu item

Values and Description

 

 

 

 

TCP/IP

Enable

 

Off: Disable the TCP/IP protocol.

 

 

 

On (default): Enable the TCP/IP protocol.

 

 

 

 

 

Host Name

 

An alphanumeric string, up to 32 characters, used to

 

 

 

identify the device. This name is listed on the

 

 

 

HP Jetdirect configuration page. The default host name

 

 

 

is NPIxxxxxx, where xxxxxx is the last six digits of the

 

 

 

LAN hardware (MAC) address.

 

 

 

 

 

IPV4 Settings

Config Method

Specifies the method that TCP/IPv4 parameters will be

 

 

 

configured on the HP Jetdirect print server.

 

 

 

Bootp: Use BootP (Bootstrap Protocol) for automatic

 

 

 

configuration from a BootP server.

 

 

 

DHCP: Use DHCP (Dynamic Host Configuration

 

 

 

Protocol) for automatic configuration from a DHCPv4

 

 

 

server. If selected and a DHCP lease exists, DHCP

 

 

 

 

28 Chapter 2 Control panel

ENWW