Table
Menu item | Values and Description | ||
|
|
|
|
IPX/SPX | Enable |
| Off: Disable the IPX/SPX protocol. |
|
|
| On (default): Enable the IPX/SPX protocol. |
|
|
|
|
| Frame Type |
| Selects the |
|
|
| Auto: Automatically sets and limits the frame type to |
|
|
| the first one detected. |
|
|
| EN_8023, EN_II, EN_8022, and EN_SNAP: Frame- |
|
|
| type selections for Ethernet networks. |
|
|
|
|
AppleTalk | Enable |
| Off (default): Disable the AppleTalk protocol. |
|
|
| On: Enable the AppleTalk protocol. |
|
|
|
|
DLC/LLC | Enable |
| Off (default): Disable the DLC/LLC protocol. |
|
|
| On: Enable the DLC/LLC protocol. |
|
|
|
|
Security | Print Sec Page |
| Yes: Prints a page that contains the current security |
|
|
| settings on the HP Jetdirect print server. |
|
|
| No (default): A security settings page is not printed. |
|
|
|
|
| Secure Web |
| For configuration management, specify whether the |
|
|
| embedded Web server will accept communications |
|
|
| using HTTPS (Secure HTTP) only, or both HTTP and |
|
|
| HTTPS. |
|
|
| HTTPS Required: For secure, encrypted |
|
|
| communications, only HTTPS access is accepted. The |
|
|
| print server will appear as a secure site. |
|
|
| HTTP/HTTPS optional: Access using either HTTP or |
|
|
| HTTPS is permitted. |
|
|
|
|
| IPsec or Firewall |
| Specify the IPsec or Firewall status on the print server. |
|
|
| Keep: IPsec/Firewall status remains the same as |
|
|
| currently configured. |
|
|
| Disable: IPsec/Firewall operation on the print server is |
|
|
| disabled. |
|
|
|
|
| Reset Security |
| Specify whether the current security settings on the |
|
|
| print server will be saved or reset to factory defaults. |
|
|
| No*: The current security settings are maintained. |
|
|
| Yes: Security settings are reset to factory defaults. |
|
|
|
|
Diagnostics | Embedded Test |
| This menu provides tests to help diagnose network |
|
|
| hardware or TCP/IP network connection problems. |
|
|
| Embedded tests help to identify whether a network fault |
|
|
| is internal or external to the device. Use an embedded |
|
|
| test to check hardware and communication paths on |
|
|
| the print server. After you select and enable a test and |
|
|
| set the execution time, you must select Execute to |
|
|
| initiate the test. |
|
|
| Depending on the execution time, a selected test runs |
|
|
| continuously until either the device is turned off, or an |
|
|
| error occurs and a diagnostic page is printed. |
|
|
|
|
ENWW | Use the Administration menu 31 |