Removing a 5.25-inch Drive from a Drive Bay

CAUTION: All removable media should be taken out of a drive before removing the drive from the computer.

1.Prepare the computer for disassembly (Preparation for Disassembly on page 97).

2.Remove the access panel (Access Panel on page 98).

3.Rotate the drive cage to its upright position.

4.If removing an optical drive, disconnect the power cable and data cable from the rear of the optical drive.

CAUTION: When removing the cables, pull the tab or connector instead of the cable itself to avoid damaging the cable.

5.Rotate the drive cage back down to its normal position.

CAUTION: Be careful not to pinch any cables or wires when rotating the drive cage down.

6.Press down on the green drive retainer button located on the left side of the drive to disengage the drive from the drive cage (1). While pressing the drive retainer button, slide the drive back until it stops, then lift it up and out of the drive cage (2).

Figure 7-15Removing the 5.25-inch Drive

Installing a 5.25-inch Drive into a Drive Bay

1.Prepare the computer for disassembly (Preparation for Disassembly on page 97).

2.Remove the access panel (Access Panel on page 98).

3.If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then remove the bezel blank. See Bezel Blanks on page 102 for more information.

114

Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis

Page 124
Image 124
HP Pro 6300 manual Removing a 5.25-inch Drive from a Drive Bay