HP Pro 6300 manual 6Computer Setup-Advanced for advanced users, Hardware Power, Thermal

Table 3-5Computer Setup—Power (continued)

Hardware Power	SATA Power Management – Enables or disables SATA bus and/or device power management.
Management	Default is enabled.
	S5 Maximum Power Savings – Turns off power to all nonessential hardware when system is off to
	meet EUP Lot 6 requirement of less than 0.5 Watt power usage. Default is disabled.
	PCI Express x16 Slot 1 – Sets Active State Power Management (ASPM) of the bus. ASPM lets you
	set lower power modes that activate when the bus is not being used. Options are Disabled, LOs,
	L1, LOs and L1. Default is ASPM Disabled.
	PCI Express x1 Slot 1 – Sets Active State Power Management (ASPM) of the bus. ASPM lets you set
	lower power modes that activate when the bus is not being used. Options are Disabled, LOs, L1,
	LOs and L1. Default is ASPM Disabled.
	Network Controller – Sets ASPM of the bus. ASPM lets you set lower power modes that activate
	when the bus is not being used. Options are Disabled, LOs, L1, LOs and L1. Default is ASPM
	Disabled.
	USB 3.0 Controller – Sets ASPM of the bus. ASPM lets you set lower power modes that activate
	when the bus is not being used. Options are Disabled, LOs, L1, LOs and L1. Default is ASPM
	Disabled.
Thermal	Fan idle mode—This bar graph controls the minimum permitted fan speed.
	NOTE: This setting only changes the minimum fan speed. The fans are still automatically
	controlled.

Computer Setup—Advanced

NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration.

Table 3-6Computer Setup—Advanced (for advanced users)

Option	Heading
Power-On Options	Allows you to set:
	● POST mode (QuickBoot, Clear Memory, FullBoot, or FullBoot Every x Days).
	◦	QuickBoot (default) = Do not clear memory or perform a memory test.
	◦	FullBoot = Memory test (count) on cold boot. Clears memory on all boots.

Computer Setup (F10) Utilities 21