HP Pro 6300 manual Memory, DDR3-SDRAM DIMMs

Memory

Description	Spare part number
8-GB, PC3-12800	689375-001
4-GB, PC3-12800	671613-001
2-GB, PC3-12800	671612-001

The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3- SDRAM) dual inline memory modules (DIMMs).

DIMMs

The memory sockets on the system board can be populated with up to four industry-standard DIMMs. These memory sockets are populated with at least one preinstalled DIMM. To achieve the maximum memory support, you can populate the system board with up to 16-GB of memory configured in a high- performing dual channel mode.

DDR3-SDRAM DIMMs

CAUTION: This product DOES NOT support DDR3 Ultra Low Voltage (DDR3U) memory. The processor is not compatible with DDR3U memory and if you plug DDR3U memory into the system board, it can cause the physical damage to the DIMM or invoke system malfunction.

For proper system operation, the DDR3-SDRAM DIMMs must be:

●industry-standard 240-pin

●unbuffered non-ECC PC3-12800 DDR3-1600 MHz-compliant

●1.5 volt DDR3-SDRAM DIMMs

The DDR3-SDRAM DIMMs must also:

●support CAS latency 11 DDR3 1600 MHz (11-11-11 timing)

●contain the mandatory JEDEC SPD information

In addition, the computer supports:

●512-Mbit, 1-Gbit, and 2-Gbit non-ECC memory technologies

●single-sided and double-sided DIMMs

●DIMMs constructed with x8 and x16 DDR devices; DIMMs constructed with x4 SDRAM are not supported

NOTE: The system will not operate properly if you install unsupported DIMMs.

62 Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis